Spindle Kit
Spindle kits are listed with fitment checks for taper condition, drawbar wear, and heat marks around the nose. In Gauteng shops, dust and stop-start power make lubrication history and bearing preload worth checking before a rebuild is booked.
Bearing Pack
Bearing packs need the right series, clearance, and sealing for the headstock or drive assembly they are going into. Where machines run long shifts on steel and cast material, noise, temperature rise, and grease condition tell you more than a part number alone.
Way Cover
Way covers are selected around travel length, mounting points, and the swarf thrown by the machine during daily cutting. Fine Highveld grit, coolant splash, and bent slats can expose slideways, so cover condition should be checked during service visits and strip-down work.
Coolant Pump
Coolant pumps are matched by mounting style, tank depth, flow requirement, and the mix used in the sump. Chips, tramp oil, and stale coolant can shorten pump life, especially where maintenance stops are delayed by production pressure.
Tool Holder
Tool holders need the correct taper, gauge length, and clamping condition for the spindle and the work being run. Rust bloom from storage, fretting on the taper, and pull stud wear are common workshop checks before tooling is put back into service.
Axis Encoder
Axis encoders are checked against mounting layout, feedback type, and cable condition before replacement is planned. On older machines, dust ingress, loose couplings, and power interruptions can show up as drift, position alarms, or repeatability faults during testing.